Browsing Food Programme by Subject "Fat content"
Now showing items 1-3 of 3
Adding value to Beef Forequarter MusclesThe forequarter constitutes 50% of the weight of a beef carcase but only about 25% of its value.To fulfill the objectives of this project, the work was organised into 4 parts as follows: 1.Characterisation of the available raw material, in terms of properties of individual muscles seamed out from carcasses of representative types of animals produced in Ireland. 2.Comparison of yields and operator time for seaming and conventional boning. 3.Utilisation of separated muscles in added-value products using appropriate tenderising, bonding and forming technology. 4.Transfer of the knowledge and technology to the industry.
Measuring the lean content of carcasses using TOBECThis project examined the potential of two objective methods of measuring the lean and fat content of meat carcasses and cuts. Total Body Electrical Conductivity (TOBEC) and Bioelectrical Impedance Analysis (BIA) are both based on the different conductivity of lean and fat tissues. TOBEC measures the absorption by a carcass or cut of electrical energy from an electromagnetic field whereas BIA measures the resistance to the flow of an electrical current. TOBEC is a large and relatively expensive piece of equipment that is fully automated. BIA is small and relatively low cost but requires an operator.
Using ultrasound to measure beef tenderness and fat contentA new acoustical technique was developed for the quantitative analysis of the texture and composition of meat and meat products. This new approach exploits the fact that the acoustical velocity and attenuation of waves propagated through meat are affected by its mechanical properties, thus allowing characterisation in terms of its composition and eating quality. The method is based on a new high-resolution ultrasonic resonator. This technique is rapid and uses small samples. Procedures for the acoustical analysis of meat were developed and the results were correlated with taste panel and shear force measurements of meat tenderness.