Browsing Animal & Grassland Research & Innovation Programme by Subject "Baled silage"
Now showing items 1-4 of 4
Conservation characteristics of baled grass silages differing in duration of wilting, bale density and number of layers of plastic stretch-filmThe effects of duration of wilting, bale density and number of layers of plastic stretchfilm used to wrap bales on the conservation characteristics of baled grass silage was investigated. Grass from the primary growth of a Lolium perenne dominant sward was wilted for 24, 48 or 72 h. For each duration of wilting, 54 cylindrical bales (1.2 m nominal diameter) were made with the baler at a high or low density setting for alternate bales. Bales were wrapped with 2, 4 or 6 layers of plastic stretch-film and stored outdoors for 295 days. Two layers of plastic stretch-film resulted in inferior preservation, lower digestibility and extensive mould growth and deteriorated silage. Substantial improvement occurred to each of these characteristics from applying four layers of stretch-film (P<0.05), while six layers of stretch-film brought little further improvement. When four or six layers of stretch-film were used, extensive wilting restricted fermentation and improved the standard of preservation with the apparently difficult-to-preserve herbage used in this experiment. However, under the anaerobic conditions provided by four or six layers of stretch-film neither progressive wilting nor bale density had a major effect on digestibility, or the extent of surface mould growth or deteriorated silage. It can be concluded that a minimum of four layers of conventional black plastic stretch-film were required to achieve suitably anaerobic conditions, and that the additional benefits from six layers were small. Once anaerobic conditions were achieved, extensive wilting improved the conservation characteristics of baled grass silage made from a difficult-to-preserve crop, whereas bale density had little impact.
Factors influencing the conservation characteristics of baled and precision-chop grass silagesThe composition of baled silage on Irish farms frequently differs from that of comparable precision-chop silage. This paper concerns a field-scale study designed to investigate: (a) the effects of number of layers (2, 4, 6 or 8) of polyethylene stretch film and the duration of storage (7 vs. 18 months) on the conservation characteristics of baled silage, and (b) the conservation characteristics of baled (4 layers of stretch film) and precision-chop silages. All silages were made following three durations of wilting (0, 24 or 48 h). Wilting restricted silage fermentation, with silage pH being highest (P<0.001) and the concentration of fermentation products lowest (P<0.001) for the 48 h wilt treatment. Wrapping bales in only 2 layers of polyethylene stretch film resulted in extensive visible mould growth, but mould growth was practically eliminated by the application of 4 or more layers of film. Silage fermentation characteristics were generally improved by wilting, and by 4 compared to 2 layers of stretch film. Extending the storage duration of baled silage from 7 to 18 months reduced (P<0.001) the concentration of fermentation products and increased in-silo fresh weight losses (P<0.001) and visible mould growth. Whereas 4 layers of conventional stretch film are normally sufficient, 6 layers may be necessary to prevent mould growth when bales of unwilted silage are stored for a second season. Under good farm-management conditions differences observed between baled and precision-chop silages probably result mainly from differences in the concentration of dry matter in herbage at ensiling.
Manipulating the ensilage of wilted, unchopped grass through the use of additive treatmentsBaled silage composition frequently differs from that of comparable conventional precision-chop silage. The lower final concentration of fermentation products in baled silage makes it more conducive to the activities of undesirable microorganisms. Silage additives can be used to encourage beneficial microbial activity and/or inhibit detrimental microbial activity. The experiment was organised in a 2 (chop treatments) × 6 (additive treatments) × 2 (stages of ensilage) factorial arrangement of treatments (n = 3 silos/treatment) to suggest additive treatments for use in baled silage production that would help create conditions more inhibitory to the activities of undesirable microorganisms and realise an outcome comparable to precision-chop silage. Chopping the herbage prior to ensiling, in the absence of an additive treatment, improved the silage fermentation. In the unchopped herbage, where the fermentation was poorer, the lactic acid bacterial inoculant resulted in an immediate increase (P < 0.001) in lactic acid concentration and a faster decline (P < 0.001) in pH with a subsequent reduction in butyric acid (P < 0.001) and ammonia-N (P < 0.01) concentrations. When sucrose was added in addition to the lactic acid bacterial inoculant, the combined treatment had a more pronounced effect on pH, butyric acid and ammonia-N values at the end of ensilage. The formic acid based additive and the antimicrobial mixture restricted the activities of undesirable microorganisms resulting in reduced concentrations of butyric acid (P < 0.001) and ammonia-N (P < 0.01). These additives offer a potential to create conditions in baled silage more inhibitory to the activities of undesirable microorganisms.
A note on the conservation characteristics of baled grass silages ensiled with different additives.The effects of contrasting conventional silage additives on chemical composition, aerobic stability and deterioration, and mould development in baled silage were investigated. Herbage from a grassland sward was wilted for 24 h and treated with acid (formic or sulphuric), sugar (molasses), bacterial (Lactobacillus plantarum, L. plantarum + Serratia rubidaea + Bacillus subtilis, or L. buchneri) or sugar + bacterial (molasses + L. plantarum) additives prior to baling and wrapping. Silage made without an additive preserved well and had a low incidence of mould growth, and the effects of additives were minor or absent. It is concluded that little practical benefit was realised when conventional additives were applied to wilted, leafy, easy-to-ensile grass prior to baling and ensilage.